ELC dmxLAN Node4
The dmXLAN node4 is a DMX512 to Ethernet and reverse converter, compatible with the Artnet protocol.
4 DMX outputs are available, ground referenced and connected to a transceiver for compatibility with RDM (Remote Device Management.
All DMX in- and outputs can be used simultaneously and independent from each other.
Further I/O are a RS232 port and a MIDI in- and output of which one of the variants can be used and 4 inputs for contacts as wel as 4 opt isolated switch outputs.
The Ethernet link is a 10BaseT connection on a Neutrik Ethercon RJ45 connector.
The unit is housed in a 19” wide 1U high rackmount case with a fixed mains lead.
The node4 can be configured via the front panel controls and LC display for simple operations. For a full functionality a PC, running the ELC dmXLAN control software, connected to the network is required. This PC is not needed during normal operation, only for configuration and at wish for monitoring nodes and universes and fixture management.
Connections :
- 10MB Ethernet 10BaseT connection on Neutrik Ethercon
- 4 DMX512 inputs on 5 pin male XLR with termination
- 4 DMX512 outputs on 5 pin female XLR, with termination and a transceiver connection for RDM compatibility
- RS-232 connection on D-sub 9 pin female
- MIDI In and Out/Thru connections on 5 pin female DIN connectors
- 2 contact closure inputs plus 2 opto isolated switched outputs on a D-sub 9 pin female connector